QA Inspector

Key responsibilities include: Moving parts through the final inspection process which includes visual, leak testing, automated CMM setup and inspection, segregating non-conformances, dimensional using measurements devices such as calipers, micrometers, pin gauges, fluke meters as needed Must be able to handle parts weighing up to 30 to 35 lbs when wet. This is due to some parts being submerged in a water tank and weighing more when wet. Operator will remove parts from a water tank, blowing off excess water with a compressed air (CDA) gun, and loading them into an oven for bake-out. The water tank and oven are located in adjacent rooms approximately 50 to 60 feet apart, with parts transported using a rolling cart rather than being carried long distances. Once dried, parts weigh approximately 21 lbs and move through a series of inspection steps. Not all parts are this heavy btw. Performing CMM setup by lifting and placing parts at arm's length onto the inspection equipment. Conducting visual inspections and documenting findings with photographs of both sides of the part, requiring the part to be picked up and rotated as needed. Working primarily independently, with most tasks expected to be performed without assistance. Physical requirements include frequent lifting, positioning, rotating, and handling of parts, as well as standing and moving between workstations throughout the shift. Final packaging parts per the POR (double bagged parts, sometimes includes double bagging the box for cleanroom enviroment packaging)