Tester II - 1st ShiftEaton's AER FMC division is currently seeking a Tester II - 1st Shift at our Irvine, CA facility! The hourly rate for this position is $25.00 per hour. The hours for this shift are 5:30 am - 2:00 pm Monday - Friday. This position is also eligible for a variable incentive program. Salaries are based upon candidate skills, experience, and qualifications, as well as market and business considerations.
What You'll Do:
The Tester is responsible for performing bench testing of a diversified line of parts, subassemblies and completed units following established procedures. In this function you will:
- Perform bench work requiring use of simple limit direct reading gauges and meters
- Build / fabricate own setup operations on less complicated test systems
- Connect products to be tested to test equipment, monitor gauges and meters, verify and record results
Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner. Understand and meet all departmental safety objectives and goals. Keep assigned work-area clean, organized, and orderly per 5S standards.
Perform Lean Initiatives including Continuous Improvement
Lead and interpret blueprints & schematics
Qualifications
Required Qualifications:- High School Diploma or GED from an accredited institution is required
- Minimum of three (3) years' work experience in Fuel, Hydraulic and/or Pneumatic Testing is required
- No relocation provided. Candidates must reside within 50 miles of Irvine, CA in order to be considered. Active Duty Military Service member candidates are exempt from the geographical area limitation.
This position requires access to export-controlled information. To conform to U.S. Government export regulations applicable to that information, applicant must be a U.S. person, defined as a (i) U.S. citizen or national, (ii) U.S. lawful, permanent resident (green card holder), (iii) refugee under 8 U.S.C. 1157, or (iv) asylee under 8 U.S.C. 1158.
Preferred Qualifications:
Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries
Position Criteria:
- Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers
- Ability to use direct reading and fixed gauges
- Able to read blueprints and schematics
- Detailed Oriented
- Works Independently
- Continuous Improvement
- Follow Safety Practices & Procedures
- Ability to lift up to 50lbs
