Job TitleDutiesThis is a Direct Hire Public Notice. Under this recruitment, applications will be accepted for each location and/or installation identified in this Public Notice and selections will be made for vacancies as they occur. There may or may not be actual/projected vacancies at the time you submit your application. This position is being filled under Direct Hire Authority (DHA) in accordance with USD(P&R) memo of APR 02 2020, Direct Hire Authority for Certain Personnel of the Department of War, Title 5, United States Code, Section 9905. Per 3. Covered Positions c. Positions in the acquisition workforce that are responsible for managing any services contracts necessary to the operation and maintenance of programs in the DoW and Positions in science, technology, engineering, or mathematics, including technician positions, within the defense acquisition workforce, or any category of acquisition positions within the DoW designated by the Secretary as a shortage or critical need category, as outlined in Table 1. Please read this Public Notice in its entirety prior to submitting your application for consideration. Incumbents typical work assignments may include the following: Operate, troubleshoot, and repair the Allen Bradley Utility Monitoring and Control System (UMCS), the ICONICS SCADA system, and various utility generation and distribution systems (e.g., Chilled Water, Steam, Electrical, HVAC, Natural Gas) with little or no supervision. Conduct operational testing of newly modified systems, perform preventive and corrective maintenance, and run first-level diagnostics on complex plant instruments, controls, and electronic devices. Respond to service calls regarding industrial control systems or equipment failures. This includes troubleshooting, repairing, programming, and installing components like variable frequency drives (VFDs), circuit boards, sensors, and Programmable Logic Controllers (PLCs).Operate, start, and shut down critical equipment (such as boilers, condensers, and feed water systems) using control room computers or manual controls. The incumbent must recognize abnormal conditions from alarms or computer screens and take steps to restore safe conditions. Inspect, troubleshoot, calibrate, and fine-tune complex systems and instruments during operational testing. This involves diagnosing and repairing malfunctioning controls either on-site or in the workshop.
