Job Description:- Set up and assist with new production runs
- Operate and monitor injection molding/production equipment
- Inspect finished parts for defects and quality issues
- Check for short parts or improperly produced products
- Trim and assemble parts as needed
- Weigh, pack, sort, and prepare finished products for shipment
- Properly mix materials required for production
- Keep sufficient material in the hopper/dryer to prevent production interruptions
- Notify supervisors of material or supply shortages
- Perform routine inspections and basic maintenance of assigned equipment
- Maintain a clean and organized work area
- Follow all workplace and equipment safety procedures
- Report unsafe conditions or behavior to a supervisor
- Work professionally and respectfully with coworkers and supervisors
Requirements:- High school diploma or GED equivalent
- Previous plastic injection molding experience required
- Experience operating and monitoring injection molding machines
- Experience with machine setup, production runs, material handling, and quality inspection
- Ability to troubleshoot basic production or machine issues
- Ability to understand and follow written and verbal instructions
- Ability to safely operate applicable tools and equipment
- Strong attention to detail and quality
- Dependable and able to work a full-time schedule
- Ability to follow company safety rules and procedures
Physical Requirements:
Candidates must be able to stand, bend, stoop, climb, kneel, crawl, and reach as required throughout the workday. Must be able to frequently lift and/or move up to 50 pounds and occasionally handle heavier materials of up to 100 pounds with appropriate assistance or equipment.
